BBO Discussion Forums: Lectern and bar-stool for vugraph presentations - BBO Discussion Forums

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Lectern and bar-stool for vugraph presentations greatly improves visability

#1 User is offline   mrdct 

  • PipPipPipPipPipPip
  • Group: Advanced Members
  • Posts: 1,448
  • Joined: 2003-October-27
  • Gender:Male
  • Location:Moama, NSW

Posted 2004-April-22, 17:27

For the recent vugraph presentation that I ran, I sat on a bar-stool at the SE corner of the table (stradling the screen) to get a nice clear view of the table. Prior to the presentation, I built a simple lectern to put my laptop on. Nothing fancy - just two pieces of chipboard cut to 500mm x 250mm connected with four 900mm legs. I put it all together with 8 long nails and it really was quite stable. It took about 5 minutes to make which I did in the carpark of the DIY centre (Bunnings) on the morning of my vugraph presentation. The materials cost less that A$5.
Disclaimer: The above post may be a half-baked sarcastic rant intended to stimulate discussion and it does not necessarily coincide with my own views on this topic.
I ♦ bidding the suit below the suit I'm actually showing not to be described as a "transfer" for the benefit of people unfamiliar with the concept of a transfer
0
Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users